Honeywell S8910U3000 Universal Igniter HSI 24VAC 120V

Overview
Universal hot surface ignition module replaces multiple field installed hot surface ignition modules supplied by Honeywell, White-Rodgers, Robertshaw and Johnson. Uses a 120 VAC igniter. Includes cross reference, instructions, and accessories for easy replacement.

Features

• Replaces over 800 White-Rodgers, Robertshaw and Honeywell hot surface ignition models.
• For 120 Vac (up to 5.0A) surface igniter (Norton 201/271 or equivalent).
• S8910U 3000 Series has LED status indicator and microammeter ports for easy trouble shooting
• For local (single rod) or remote (dual rod) rectification type flame sensing.
• Contains easy-to-use cross reference and instructions plus the accessories required to replace the existing hot surface ignition module.
• Provides one or three ignition trials (four-second or seven-second trials) per call for heat.
• Field selectable number of ignition trials and trial time based on unit being replaced.
• Igniter warm up time: 7 (12 seconds second and third trial), 17 (27 seconds second and third trial), 34, or 45 seconds

Product Specifications

• Dimensions (in.)5 1/4 in. high x 4 1/16 in. wide x 1 15/16 in. long
• Dimensions (mm)133 mm high x 103 mm wide x 49 mm deep
• Electrical Ratings 24 Vac
• Frequency 60 Hz
• Approvals, Canadian Standards Association Design Certified
• Flame Failure Response Time (sec) 1.5 sec.
• PrePurge 32 seconds
• Ambient Temperature Range (F) -40 F to +175 F
• Ambient Temperature Range (C) -40 C to +79 C
• Ignition System Type
• Direct Hot Surface Ignition
• Ignition SequenceThe number of trials for ignition and trial time is determined by the selection tab. If a selection tab is not installed, the module will operate at four seconds trial time and one ignition trial.
• Typical Gas Control VR8205, VR8305
• Type of Gas Natural or LP
• Flame Sense Single Rod or Two Rods
• Ignition Source Line Voltage (120 VAC) Hot Surface Element (Norton Model 201 or 270)
• Ignition Trials To Lockout 1 or 3
• Lockout Timing4 sec. or 7 sec.
• Ignition Trial Time (sec) 4 sec. or 7 sec.
• Maximum Valve Load @ 24 Vac (Amps)2A
• Typical Ignition Hardware Norton 201, Norton 271, Q354
• Between Trial Time (sec)(2) 96 sec.- 3 trial mode only